创建一个网站的项目体现项目完成速度因素的专门发布采购信息的网站
背景：
第一次接触TI的芯片，对其中遇见的问题或者不清楚的地方做个记录。
问题及解决方法
1.头文件未包含
添加对应头文件
解决方法
2. error #10008-D: cannot find file “C:/ti/Hercules/SafeTI Diagnostic Library/2.4.0/libs/SafeTILib_TMS570LC43_BE.lib”：
需要下载官方demo.exe,但是官方demo需要labview2010环境，笔者当时使用不了
解决方法
需要下载demo.exe，文件安装之后，对应文件在这个安装包里面
然后添加对应路径就行。
3.校验失败：
解决方法
在官网海淘解决方案：
n CCS “Flash Settings”, please check the following items:
- System Reset on Connect is checked
- Auto ECC Generation is unchecked
- Align program segments to 64-bit memory regions is checked
- Flash Verification Settings should be ‘None’
- Perform Blank Check before Program Load must be unchecked
勾选图中选项
4. error #10234-D: unresolved symbols remain
error #10010: errors encountered during linking; “test.out” not built
解决方法
修改完图中提示的未定义部分，问题解决
5. Error connecting to the target:
(Error -151 @ 0x0)
One of the FTDI driver functions used during the connect
returned bad status or an error. The cause may be one or
more of: no XDS100 is plugged in, invalid XDS100 serial number,
blank XDS100 EEPROM, missing FTDI drivers, faulty USB cable.
Use the xds100serial command-line utility in the ‘common/uscif’
解决方法;修改仿真器
6.Error connecting to the target:
(Error -180 @ 0x0)
The controller has detected a target power loss.
The user must turn-on or connect the power supply for the target.
(Emulation package 20.0.0.3178)
解决方法
绿色板子必须用12V供电才好使
7.Error initializing emulator:
(Error -2083 @ 0x0)
Unable to communicate with the debug probe. Confirm debug probe configuration and connections, reset the debug probe, and retry the operation.
(Emulation package 20.0.0.3178)
8.Printf 无法输出%d
解决方法：
重写printf函数
9.已使用RAM空间过大
解决方法：
修改前
source/HL_sys_link.cmd", line 86: error #10099-D: program will not fit into available memory, or the section contains a call site that requires a trampoline that can’t be generated for this section. run placement with alignment fails for section “.bss” size 0x19334. Available memory ranges:
修改后：
