当前位置：首页 > wzjs >正文

自己做交易网站网站联盟

wzjs 2025/9/5 11:28:11

自己做交易网站,网站联盟,WordPress臃肿主题,成都五月花网页设计培训Arduino示例代码讲解：Project 07 - Keyboard 键盘 Project 07 - Keyboard 键盘程序功能概述功能：硬件要求：输出：代码结构全局变量`setup()` 函数`loop()` 函数读取电位器值：打印电位器值：播放音调：运行过程注意事项Project 07 - Keyboard 键盘 /*Arduino Starter Kit e…

Arduino示例代码讲解：Project 07 - Keyboard 键盘

Project 07 - Keyboard 键盘
- 程序功能概述
- - - 功能：
    - 硬件要求：
    - 输出：
- 代码结构
- - - 全局变量
    - `setup()` 函数
    - `loop()` 函数
    - 读取电位器值：
    - 打印电位器值：
    - 播放音调：
- 运行过程
- 注意事项

Project 07 - Keyboard 键盘

/*Arduino Starter Kit exampleProject 7  - KeyboardThis sketch is written to accompany Project 7 in theArduino Starter KitParts required:two 10 kilohm resistors1 Megohm resistor220 ohm resistor4 pushbuttonspiezoCreated 13 September 2012by Scott Fitzgeraldhttp://arduino.cc/starterKitThis example code is part of the public domain
*/// create an array of notes
// the numbers below correspond to
// the frequencies of middle C, D, E, and F
int notes[] = {262, 294, 330, 349};void setup() {//start serial communicationSerial.begin(9600);
}void loop() {// create a local variable to hold the input on pin A0int keyVal = analogRead(A0);// send the value from A0 to the Serial MonitorSerial.println(keyVal);// play the note corresponding to each value on A0if (keyVal == 1023) {// play the first frequency in the array o