当前位置：首页 > wzjs >正文

网站工程是干啥的网店运营策划方案

wzjs 2025/8/22 17:31:31

网站工程是干啥的,网店运营策划方案,网站制作常见的问题,网络网站制作技巧Arduino示例代码讲解：Knock Sensor 敲击感知器 Knock Sensor 敲击感知器功能概述硬件部分：软件部分：代码逐行解释定义常量定义变量`setup()` 函数`loop()` 函数工作原理Knock Sensor 敲击感知器这段代码是一个Arduino示例程序，用于检测敲击声。它通过读取一个压电元件（p…

Arduino示例代码讲解：Knock Sensor 敲击感知器

Knock Sensor 敲击感知器
- 功能概述
- - - 硬件部分：
    - 软件部分：
- 代码逐行解释
- - - 定义常量
    - 定义变量
    - `setup()` 函数
    - `loop()` 函数
- 工作原理

Knock Sensor 敲击感知器

这段代码是一个Arduino示例程序，用于检测敲击声。它通过读取一个压电元件（piezo element）的模拟输入值，并将其与一个设定的阈值进行比较。如果读取的值超过阈值，它会在串行端口输出“knock”，并切换引脚13上的LED的状态。这种方法适用于需要检测敲击或其他声音信号的场景。

/* Knock SensorThis sketch reads a piezo element to detect a knocking sound.It reads an analog pin and compares the result to a set threshold.If the result is greater than the threshold, it writes"knock" to the serial port, and toggles the LED on pin 13.The circuit:* + connection of the piezo attached to analog in 0* - connection of the piezo attached to ground* 1-megohm resistor attached from analog in 0 to groundhttp://www.arduino.cc/en/Tutorial/Knockcreated 25 Mar 2007by David Cuartielles <http://www.0j0.org>modified 30 Aug 2011by Tom IgoeThis example code is in the public domain.*/// these constants won't change:
const int ledPin = 13;      // led connected to digital pin 13
const int knockSensor = A0; // the piezo is connected to analog pin 0
const int threshold = 100;  // threshold value to decide when the detected sound is a knock or not// these variables will change:
int sensorReading = 0;      // variable to store the value read from the sensor pin
int ledState = LOW;         // variable used to store the last LED status, to toggle the light